Joints for split 3D prints: dovetail, puzzle, pins, screws and magnets
For a large 3D print made of several parts, use pins and glue for a quick mockup, dovetails or puzzle seams when the parts should align themselves, M3 screws when it must hold weight or come apart again, and magnets when it should open and close. Leave about 0.2 mm of clearance in any joint.
Seams: the shape of the cut
| Seam | How it goes together | Good for |
|---|---|---|
| Straight | Push straight on | Fast mockups, parts that will be glued and painted |
| Zigzag | Push straight on | More glue area and no sliding sideways |
| Puzzle | Slides in from the side | Parts that should lock without clamps |
| Dovetail | Slides in from the side | The strongest self aligning seam; easy to see how it fits |
A seam that slides in from the side cannot be pulled straight apart, which is what makes it strong. It also means the order of assembly matters when seams cross.
Joins: what holds it
| Join | What it is | Pick it when |
|---|---|---|
| Pins and glue | Printed pins in matching holes, glued | You want it fast and permanent |
| Clips | A printed key that snaps into both parts | You want it together without glue |
| M3 screws | A screw through one part into the other | It carries load or must come apart |
| Magnets | 6 mm round magnets pressed into pockets | It should open and close |
Clearance
A joint drawn with no gap will not fit after printing. About 0.2 mm is a normal starting point. A loose printer or a material that swells may want 0.3 mm; a well tuned one can go down to 0.15 mm. Print a short test strip with a few different gaps and use the one that feels right.
Tips
- Dry fit first. Put everything together without glue to find the order.
- Glue as the seam closes. On a sliding seam, add glue just before the last few millimetres.
- Keep joints away from thin walls. A pin hole near the surface shows through.
- Number the parts. Eight similar looking parts of a ball are hard to tell apart.
CadSplit adds any of these seams and joins for you, sizes them to the model, and has a slider for fewer, bigger tabs or more, smaller ones.
Questions
What is the strongest joint for a split 3D print?
A dovetail seam with glue or M3 screws. The dovetail stops the parts pulling apart and keeps them aligned while the glue sets.
How much clearance should a 3D printed joint have?
About 0.2 mm is a normal starting point. Test with a small strip, because it varies with the printer and the material.
Do I need glue with dovetail or puzzle seams?
Not always. They hold on their own for a mockup. Use glue or screws when the print will be handled or carry weight.